Never Saddle A Dead Horse Cable Clamp. Applying wire rope clips. “never saddle a dead horse” is a common phrase to help people remember the proper orientation to apply the clip. It means to never apply the.
Yes there is a proper way and an improper way to put the clamp on. The cable that attaches to the load should be on the bottom. Apply first clip one base width from dead end of rope.
Don't saddle a dead horse | The saddle on a Crosby clamp is … | Flickr
showing the correct way to install Wire Rope Cable Clamps. Never Saddle A Dead Horse Cable Clamp
In the rigging and lifting industry there is a common saying that is used to remember the correct way to use wire rope u clips: “never saddle a dead horse. ” this means that the saddle of the u. It hurts your back and you gotta look pretty. Never saddle a dead horse, refers to the way to put on the cable clamps onto to wire braid cable.
Use torque wrench to tighten nuts evenly,. In order for the clamp to work under load, the end of the cable which attaches to the load must be the part in the bottom of the saddle. The dead end is on top. Thus, don't saddle a.
NEVER SADDLE A DEAD HORSE | Catchy idea, huh? Having worked … | Flickr
This video shows failure due to improper use of a Crosby G-450. This is known as "Saddling a Dead Horse". It is very important to follow all manufacturer and OSHA guidelines for lifting and rigging equipment.
Adding Thimbles to new Wire Rope.
Dan Kane Guardrails Wire Rope Clips. Note About Video Clips: The statements, technical information and recommendations contained in our video clips are believed to be accurate as of the date they were recorded. Since the conditions and methods of use of the product and of the information referred to therein are beyond our control, Diamond Tool expressly disclaims any and all liability as to any results obtained or arising from any use of the product or reliance on such information; NO…
Shop wire rope clips here bit.ly/3nd3Tnw In this video, we'll show you how to use and install Wire Rope Clips. We demonstrate the processes of assembling an eye on a wire rope, using a pulley as a thimble, creating a lap splice to connect two sections of wire rope, using and sizing vinyl coated cable, and how to use and assemble stamped cable clamps. We're the Amazon of rigging! Check us out bit.ly/3DSxzfF Check out our How to Select the Correct Wire Rope Clip Video: …
How to properly install wire rope clips/cableclamps
Cable Clamps , Never Saddle A Dead Horse
When placing a saddle clamp on a cable or wire rope, the saddle is the curved part of the clamp with threads. The clamp is the piece that fastens on and pinches the wire rope. When rigged with the saddle side of the clip on.
Never Saddle A Dead Horse Cable Clamp. This is known as saddling a dead horse. It is very important to follow all manufacturer and.