2007 Honda Aquatrax F-12x Turbo Problems. 2007 honda aquatrax code :25. It won't let you rev above 3500 rpm. I diagnosed tj as a knock sensor.
To test this valve, take the 1/4 air hose off the t at the turbo and. Failure (truncated version) honda aquatrax engine cooling system teardown (milky oil). Erie 2007 honda aquatrax rx12 turbo + solas.
2007 Honda Aquatrax F-12X Turbo – Is it worth? – PWC Forum: The best
This is a common problem on these skis. f12x and f15x Turbo models. engine runs great but ski will keep and go into limp mode gradually getting worse. could be sticking waste gate controlled by the waste gate actuator. you can reuse exhaust gasket. take off intake tube and then exhaust. 12mm socket and a flat head screw driver. the is a C- clip holding actuator arm to wastegate lever. very tricky to get off. have another one handy. good luck. please subscribe.. 2007 Honda Aquatrax F-12x Turbo Problems
Below is the information on the 2007 honda aquatrax® f. No problems to date w regular maintenence. If you would like to get a quote. When bad, you will lose about 10mph and 1k rpm.
2007 honda aquatrax f12x help!! Also take a look at the oil, make sure there is no water in there. If it looks like cream coffee you have water in. I have 2007 honda aquatrax gpscape that was bought new last year.
2007 Honda AquaTrax F-12X Gallery 177450 | Top Speed
Knowledge is power, feel free to message me any questions. I got these two aquatrax for free!!
New Turbo Installed by MotoWorld 2016-07-22. Fails on 2016-07-26. Ski goes from 60 to 28 MPH while at full throttle. Update 8/2017: The problem ended up being a clogged fuel filter, The issue that led to the initial turbo replacement was most likely caused by a bad actuator. The Ski was taken to Havasu Watersports where the repair was accurate and quick.
This is fairly easy to do and will fix your stuck turbo problem. Took me 15 mins to do it. Hope this helps.
This sound happens when I try to get in boost. Then the engine dies, sometimes stalling completely out. Sounds like a boost leak. The wastegate appears to be functioning properly.
Removing the C clip holding the actuator arm connected to the waste gate. Hard clip to remove. I placed my phone to record on my turbo to even be able to see. Good luck.
When you use zip tie, you have to drive the jet will go slower, but if the problem is in the valve will not give it as a mistake.
Honda Aqua Trax Turbo limp mode problem waste gate actuator
Final Words
Looking at buying a 02.
2007 Honda Aquatrax F-12x Turbo Problems.
